Sending A Fax Using Monitor/Call Or A Handset - Muratec MFX-2530 Operating Instructions Manual

7
If you want to send more pages, proceed to step 8.
Otherwise, press to start the transmission, and skip to step 9.
START
8
Place the next page, then press [Start] to start scanning.
To send any more pages, repeat this step.
Otherwise, press [Exit] to start the transmission, and skip to step 9.
9
Now, everything is up to the machines — yours and the one you're dialing.
When it makes contact, your machine transmits the stored document from
memory.
Note: If you want to cancel a transmission while scanning the document,
press the key.
STOP
If you want to cancel a transmission in progress, use the Job Review
function. See "Canceling commands" on page 3.6.
10
After transmission, the machine beeps and return to its standby mode.
Note: If the call fails, see "Redialing," page 3.6.

Sending a fax using monitor/call or a handset

You may also fax a document using either the monitor speaker or the optional hand-
set to dial.
1
Place the document in the .
ADF
Note: In this function, you cannot use the
2
Adjust resolution and contrast if necessary.
3
Obtain a dial tone, either by:
• Pressing /
MONITOR CALL
... or ...
• Lifting the optional handset.
In either case, the shows (see right):
LCD
4
Enter the fax number.
Also, enter access codes with the number, just as for a regular phone call.
5
When you hear fax tones from the remote unit, press
Note: If a person answers the phone, use the optional handset to tell the
person you're trying to send a fax. When you hear fax tones, press
.
START
6
If you're using an optional handset, hang up after pressing
7
After transmission, the machine beeps and returns to its standby mode.
Note: If the call fails and you used
/ to hang up. Or if you've pressed
MONITOR CALL
transmission, press
STOP
Also see "Redialing manually," next page, if the call fails.
Overseas transmission mode
This mode instructs your fax to compensate for the poor transmission
characteristics of some overseas telephone lines. To set overseas mode:
1
Enter the fax number using the numeric keypad.
2
Press until the [Overseas] is appeared.
NEXT
Then press [Overseas].
Note: This feature automatically deactivates itself
following each dialing.
glass.
FBS
Tel Mode
Enter phone number
12345678 _
Redial Hold Tone
.
START
.
START
/ to dial, press
MONITOR CALL
to begin the fax
START
to end it.
Transmission
Press START.
12345678_
Overseas
Basic fax
3.5