US Robotics MAXg User Manual page 82

Wireless MAXg Access Point User Guide
User Guide
The Wireless Nd1 Access Point does not appear when I scan
for it with a wireless client.
Solution:
The access point may not be broadcasting its network name.
1. Using a computer connected to the same networking device as the access point,
start a Web browser.
2. Type the IP address of the access point, and press ENTER to display the
configuration pages of the access point. You can get the IP address from the
Network Device Locator.
3. Click the Wireless tab and verify that Broadcast network name is selected. If it is
not selected, select it, scroll to the bottom of the Wireless page, and click Save.
Solution:
Disconnect the network cable from the client device before scanning for the access point.
Return to Troubleshooting page
© 2007 U.S. Robotics Corporation
file:///G|/CSO/T-Writer%20Repository/Networking/5455%2...0CR%20AP/Regulatory%20Preview/trouble_client_scan.html (1 of 2)4/24/2007 5:15:56 PM
Wireless MAXg Access Point: