Windows Users - US Robotics MAXg User Manual

Hide thumbs Also See for MAXg:

Table of Contents

Wireless MAXg Access Point User Guide

After you restore the access point to its factory default settings,

basic settings

restore the settings

2. Reapply the firmware upgrade.

Solution

The firmware image may have been corrupted during the upgrade procedure. Perform

the following procedure to force the upgrade:

1. Using a networking cable and the same computer that you were using when the

upgrade failed, connect the computer directly to the same networking device as the

access point. Do not try to use a wireless connection for this procedure.

2. Windows users:

A. If you do not know the IP address of the access point, run the

Device Locator

B. Locate the folder that contains that firmware file that you downloaded.

C. Open a command prompt as follows:

file:///G|/CSO/T-Writer%20Repository/Networking/5455%...g%20CR%20AP/Regulatory%20Preview/trouble_upgrade.html (2 of 4)4/24/2007 5:15:56 PM

of the access point, or, if you made a backup of your settings,

by using the backup.

to find the IP address.

reconfigure the

Network

Table of Contents

Do you have a question about the MAXg and is the answer not in the manual?