US Robotics MAXg User Manual page 26

file:///G|/CSO/T-Writer%20Repository/Networking/5455%20MAXg%20CR%20AP/Regulatory%20Preview/install.html
If you are using an operating system other than Windows, you first need to find the IP address of the
access point. Then you can start the setup wizard to configure the basic settings of the access point.
Find the IP Address of the Access Point
The networking device to which you connected the access point assigns IP addresses on your local
network. To find the IP address of the access point:
1. Access the configuration program or configuration pages of the networking device. For detailed
instructions, consult the documentation for the networking device.
2. Find the list of clients associated with the networking device.
3. On the client list, find the LAN MAC address of the access point.
You can find the LAN MAC address of the access point on the label on the bottom of the access point.
4. Note the IP address associated with the LAN MAC address of the access point.
Run the Setup Wizard
1. Start your Web browser.
2. In the location or address line, type the IP address of the access point and press ENTER.
The wizard displays its welcome page:
Step Three: Configure Basic Settings
file:///G|/CSO/T-Writer%20Repository/Networking/5455%20MAXg%20CR%20AP/Regulatory%20Preview/install.html (7 of 10)4/24/2007 5:15:20 PM