US Robotics MAXg User Manual page 78

Hide thumbs Also See for MAXg:

Table of Contents

Wireless MAXg Access Point User Guide

User Guide

After I performed a firmware upgrade, the access point did not

display its status page.

Solution

The upgrade may still be in progress. Wait for at least two minutes.

Solution

If you received the upgrade completion message, reboot the access point by

disconnecting and then reconnecting its power supply.

Solution

1. Restore the factory default settings of the access point to reactivate it.

Note:

lose all custom settings.

To restore the factory default settings, use a small object such as a paper clip to

press in and hold the reset button on the back of the access point for 7 seconds.

file:///G|/CSO/T-Writer%20Repository/Networking/5455%...g%20CR%20AP/Regulatory%20Preview/trouble_upgrade.html (1 of 4)4/24/2007 5:15:56 PM

Wireless MAXg Access Point:

When you restore the factory default settings, the access point will

Table of Contents

Need help?

Do you have a question about the MAXg and is the answer not in the manual?