US Robotics MAXg User Manual page 40

Wireless MAXg Access Point User Guide
LAN
IP address: The IP address that your access point uses on the LAN.
Subnet mask: The LAN interface Subnet Mask of your access point.
MAC address: The MAC address of your access point.
Clients
Note: Any devices connected to the access point that have static IP addresses will
not show up in the Clients list. Also, devices that are connected through a WDS
connection will be displayed as wired clients.
MAC Address: The MAC address of the connected device.
Association Time: The time since the wireless client last associated with the access
point.
Authorized: If the client is authorized to connect to this access point, the status will
display as Yes. If the client is not to connect to the networking device or Wireless
MAXg Access Point, the status will display as No.
WMM Link: If the client supports WMM, the status displays Yes. If the client does not
support WMM, the status displays No.
Power Save: If the client is running in Power Save mode, the status displays Yes. If
the client is not in Power Save mode, the status displays No.
file:///G|/CSO/T-Writer%20Repository/Networking/5455%20MAXg%20CR%20AP/Regulatory%20Preview/status.html (3 of 4)4/24/2007 5:15:45 PM