US Robotics MAXg User Manual page 30

Hide thumbs Also See for MAXg:

Table of Contents

Wireless MAXg Access Point User Guide

User Guide

Wi-Fi Protected Setup™ Configuration

The Wireless MAXg Access Point supports Wi-Fi Protected Setup™ (WPS). You can use

WPS to configure your wireless network using a push button or PIN code.

Only certain wireless adapters in Windows Vista and Windows XP, Service Pack 2, can use

Wi-Fi Protected Setup. See the documentation for your wireless adapter to determine

whether your wireless client can configure the Wireless MAXg Access Point using Wi-Fi

Protected Setup.

To configure the access point for WPS, follow these steps:

Note to reviewers: This draft requires two perspectives for WPS: using an

external registrar and using an internal registrar. Please ignore the following

set of steps.

1. Be ready to start WPS on your wireless adapter.

Once you reboot the access point during this procedure, you have 2 minutes to

start the WPS setup on your wireless adapter.

2. Reboot the access point by disconnecting and then reconnecting its power supply.

3. Start a web browser.

to configuration pages for the access point.

5. In the lower right corner of the page is an eight-digit WPS PIN. Note the PIN

because you need it in oder to configure the router using WPS.

file:///G|/CSO/T-Writer%20Repository/Networking/5455...MAXg%20CR%20AP/Regulatory%20Preview/install_wps.html (1 of 2)4/24/2007 5:15:44 PM

Wireless MAXg Access Point:

Table of Contents

Need help?

Do you have a question about the MAXg and is the answer not in the manual?