Drive Installation - Western Digital Ultrastar Data102 Installation Manual

Installation Guide
Figure 55: Chassis Handle Operation
Step 4 : Perform this same action two more times without the drives loaded to make sure the rail kits are
installed properly.
W hat to do next: T he top cover is now installed, and extension of the enclosure for servicing has been
tested. Proceed to
5.8 Drive Installation
This procedure provides instructions for installing drives in an Ultrastar Data102 .
Before you begin: Complete the instructions in
Table 40: Installation Requirements
Tool(s): N/A
Part(s): 3.5in HDD Assembly and/or 2.5in SSD Assembly
Person(s): 1
Time: 30 minutes
Note: The 2.5in SSD Assembly is installed in the same manner as the 3.5in HDD Assembly. For
instructions on assembling the 2.5in SSD Assembly, see
75).
Note: When installing drives, populate the enclosure from left-to-right, rear-to-front. For
example, begin with slot 90 (as shown in the following diagram), continue through 101, then
proceed with 78 through 89, and so on:
Drive Installation (page 70).
Top Cover Installation and Extension Test (page
Operating the 2.5" Drive Carrier (page
5. Installation

5.8 Drive Installation

68).
70