Example Of Emulator Connection - Renesas H8S Series User Manual

H8S, H8SX Family E10A-USB Emulator
1.4

Example of Emulator Connection

The figure shown below is an example of connecting the user system to the emulator.
14-pin connector with
a 2.54-mm pitch
(3M Limited: 2514-6002)
11
1
2
3
5
6
4
7
8 to 10
12 to 14
E10A-USB pin no.
· RES(in)# of pin 4 of the user system connector is a signal line in which the emulator outputs signals to the MCU.
RES(in)# (pin 4) and the user logic reset circuit for the signal line must be connected to the MCU as shown above.
· RES(out)# of pin 7 of the user system connector is a signal line in which the emulator monitors the RES# signal of
the MCU. The RES# must be pulled up before it is connected to pin 7 of the user system connector.
R20UT2526EJ0300 Rev. 3.00
Mar 14, 2013
Section 1 Connecting the Emulator with the User System
Vcc
User logic
Figure 1.3 Example of Emulator Connection
Pulled up at 4.7 kΩ
EMLE
P37/TCK
P34/TRST#
P63/TDO
P35/TMS
P36/TDI
RES#
User system
MCU
Page 6 of 30