Renesas H8S Series User Manual page 23

H8S, H8SX Family E10A-USB Emulator
(2) Limitations on the Conflict Conditions of Parallel Transfer Enabled
Memory access by parallel transfer will be limited in the following conflict conditions.
⎯ During software standby, a recovery with the [STOP] button will cause a malfunction of
parallel transfer (a timout error will occur). A recovery should be operated by the user
reset.
⎯ If the memory access is performed by a parallel transfer when the user reset is input or
watchdog timer (WDT) is reset, a malfunction of parallel transfer will occur (a write-
disabled or indefinite value will be read).
⎯ If the emulation mode is switched when the user reset is input or watchdog timer (WDT) is
reset, a malfunction of parallel transfer will occur (a timout error will occur).
(3) Access Size of Parallel Transfer
⎯ During parallel transfer, when memory is accessed by the address except at the boundary
of words or longwords, it is compensated to the boundary of access size.
R20UT2526EJ0300 Rev. 3.00
Mar 14, 2013
Section 2 Specification of the Emulator's Software
Page 19 of 30