Renesas H8S Series User Manual page 15

H8S, H8SX Family E10A-USB Emulator
12. Emulation on Programming or Erasing the Internal Flash Memory
A break cannot be generated while the program for programming or erasing the internal flash
memory is being called. Note that the following processing also cannot be performed:
⎯ Execution of the [STOP] button
⎯ Auto-update of the watch function and use of the tool-chip watch function
⎯ Memory operation during executing emulation
13. Note on Access to Memory
When data-flash memory within the emulator is accessed etc. and the EEPROM read
permission register has not been set, a FIFE (Flash Interface Error) interrupt will be generated
when the user program is executed.
14.Note on FCU RAM Data
If data in the FCU RAM are destroyed, subsequent flash-memory writing is not guaranteed.
15.Note on Flash Memory Synchronization Function
The data cannot be read-out from flash memory after a transition to ROM/PE mode etc. If
flash memory synchronization is used in this situation and data are read out from flash
memory, correct data will not be displayed and data in flash memory may be overwritten.
16. [Run Program], GO_TILL Command
[Run Program], GO_TILL command function is not available in this software.
17. Data Flash (EEPROM)
Debugging the memory for data-flash area is available by using the setting described in
section.2.2.8, Debugging in the External Flash Memory.
R20UT2526EJ0300 Rev. 3.00
Mar 14, 2013
Section 2 Specification of the Emulator's Software
Page 11 of 30