Renesas H8S Series User Manual page 27

H8S, H8SX Family E10A-USB Emulator
Table 2.8 Items in [External Flash memory setting] Dialog Box (cont)
No. Item
9 Writing module address
10 Access size
11 Top address
12 End address
13 Bus width
14 Erasing time
15 Block count
16 Top address of block
17 Remarks
Note: Make settings in accord with the region of memory on the individual device.
R20UT2526EJ0300 Rev. 3.00
Mar 14, 2013
Section 2 Specification of the Emulator's Software
Description
Entry address of the write module
Select the unit of accesses for transfer of the programs.
8bits(Byte): Bytes
16bits(Word): Words
32bits(Long): Longwords
Top address of the flash memory
End address of the flash memory*
Select the unit of accesses to the flash memory.
8bits(Byte): Bytes
16bits(Word): Words
32bits(Long): Longwords
Waiting time for erasure (in seconds)
(Specification of a decimal or hexadecimal value is
recommended.)
Number of blocks in the flash memory
(Specification of a decimal or hexadecimal value is
recommended. Up to 1024 blocks can be specified.)
Define the start addresses of all blocks. If the flash memory
has D'10 blocks, the definition will be as shown below. Press
the Return key between the definitions for each of the blocks.
Example:
H'0
H'1000
H'2000
H'3000
H'4000
H'5000
H'6000
H'7000
H'8000
H'9000
Use for writing a text. Contents of data that has been set can
be entered. If not specified, setting is not needed.
Page 23 of 30