Renesas H8S Series User Manual page 32

H8S, H8SX Family E10A-USB Emulator
[Channel 2] group box: Settings on PA2
[Don't care] checkbox
[BC2 -> BC1] radio button
[BC1 -> BC2] radio button
[Trigger to start] button
[Trigger to stop] button
[Rate] group box: Form of the measurement results
PA1/PA2
PA2/PA1
R20UT2526EJ0300 Rev. 3.00
Mar 14, 2013
Section 2 Specification of the Emulator's Software
Selected:
Performance measurement will not be performed on PA2.
Not selected:
Performance measurement will be performed on PA2.
PA2 is for measuring the number of execution cycles between
two points.
Measurement starts with satisfaction of break condition 2 and
stops with satisfaction of break condition 1.
Measurement starts with satisfaction of break condition 1 and
stops with satisfaction of break condition 2.
Clicking on this button opens a [Break condition] dialog box for
the condition to start measurement.
Clicking on this button opens a [Break condition] dialog box for
the condition to stop measurement.
Rate of PA1 to PA2
Rate of PA2 to PA1
Page 28 of 30