Heartland GENTRY GABLE VALUE Series Assembly Manual page 43

PARTS REQUIRED:
x1 PYA
2 x 4 x 19-3/4" (5,1 x 10,2 x 50,2 cm)
x2 AO
2 x 4 x 22-1/2" (5,1 x 10,2 x 57,1 cm)
x1 NK
2 x 3 x 48" (5,1 x 7,6 x 121,9 cm)
x1 PT
2 x 3 x 96" (5,1 x 7,6 x 243,8 cm)
Install loft support parts NK and PT level across left wall studs. Flush parts under front and back wall top plates.
4
Ensure 77-1/2" (196,8 cm) between floor deck and the seam.
Secure parts with (2) 3" nails in each stud.
Flush
FRONT
WALL
Install parts PYA and AO between back wall studs
5
at measurement shown below top plate and flush
to wall panel (Fig. A).
Secure parts with (2) 3" nails in AO and (6) 3" screws
as shown.
Pre-drilling is suggested for screws.
6 Install part AO between front wall studs above window
opening at measurement shown below top plate
and flush to wall panel (Fig. A).
Secure with 3" nails.
LOFT JOISTS
LEVEL
SEAM
NK
77-1/2"
(196,8 cm)
x22
x6
3" (7,6 cm)
Nails
PT
LEFT WALL
3" (7,6 cm)
Screws
BACK
WALL
PYA
3" (7,6 cm) Nails
AO
FRONT
41
3" (7,6 cm)
3" (7,6 cm)
Flush
BACK
WALL
AO
3-1/2" Fig. A
(8,9 cm)
3" (7,6 cm)
Nails
WALL
3" (7,6 cm)
Nails