Advertisement
PARTS REQUIRED:
x27
2" (5,1 cm)
x13
1-1/2" (3,8 cm)
BEGIN
1
Center back gable wall on the fl oor.
Ensure 1-1/2" measurement is at the top.
Secure wall with (1) 2" screw into side wall
bottom plate (Fig. A) and top plate
(Fig. B).
Secure wall to bottom plate fi rst.
ENSURE PANEL CORNERS ARE FLUSH.
2
Nail lower edge of panels to fl oor with 2" nails
spaced 6" apart.
Angle nails into the fl oor frame (Fig. C).
Secure wall bottom plates to fl oor with 3" nails
(Fig. C).
Nail panel to side wall stud with 1-1/2" nails
spaced 6" apart..
3
Secure wall top plate with (1) 3" screw
at the corner at an angle,
as shown in (Fig. D).
Do not nail
in groove.
FINISH
Your back gable wall is now installed.
GABLE WALL INSTALLATION
x2
x1
2" (5,1 cm)
Screw
1-1/2" (3,8 cm)
Nails
3" (7,6 cm)
Nails
Nail 2" nails fi rst.
2" (5,1 cm)
Nails
Fig. C
x12
2" (5,1 cm)
3" (7,6 cm)
Flush
Fig. A
6" (15,2 cm)
6"
(15,2 cm)
25
3" (7,6 cm)
Fig. B
3" (7,6 cm)
Screw
Fig. D
3" (7,6 cm)
Nails
2" (5,1 cm)
Nails
2" (5,1 cm)
Screw
1-1/2"
(3,8 cm)
Advertisement
