Installation Instructions; Fan Preparation; Ceiling Hardware; Getting Started - Casablanca Malibu Star Owner's Manual

Casablanca malibu star ceiling fans: owners manual

Hide thumbs Also See for Malibu Star:

Owner's manual (10 pages)

Table Of Contents

Table of Contents

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them

against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.

This fan is designed for installation on ceilings with a minimum height of 10 feet from the floor. The

large blades require the use of the 12" extension pole to allow for proper air flow and ventilation.

ALLEN SET SCREW

⁄

-20 x

⁄

(PRE-INSTALLED)

IMPORTANT SAFETY INFORMATION!

BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, INSTALL THE

THREADED DOWNROD INTO THE MOTOR COUPLING AND LOCK THE ASSEMBLY

Prepare for fan installation as follows:

Step A. Route the wires from the motor through the

Perma • Lock™ downrod and ball assembly.

Tip: The downrod has a tapered thread

that is designed to lock completely when

correctly installed.

Step B. Using the provided allen wrench, loosen the set screw

several turns to allow installation of the downrod. Thread

the downrod into the motor coupling until it stops turning,

this will take at least four and a half full turns.

Step C. Securely tighten the set screw with the provided allen

wrench to ensure safe operation of your fan.

CAUTION: Failure to fully lock in the down-

rod before securely tightening the allen set

screw may cause the fan to separate from

the downrod during normal operation!

CROSSBAR

MOUNTING

BRACKET

Installing a New Ceiling Fixture Outlet Box

If you do not have an existing fixture located where you wish

to place your Casablanca fan, an approved ceiling fixture

outlet box must be installed and wired.

Warning: To reduce the risk of fire, electrical shock,

or personal injury, mount to outlet box marked

acceptable for ceiling fan support using the mount-

ing hardware provided with the outlet box.