Installation Instructions; Fan Preparation; Ceiling Hardware; Getting Started - Casablanca Bel Air Owner's Manual

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
IMPORTANT! To avoid possible damage to the Halogen bulb holder the fan must be placed on the styrofoam packaging
from the box. After removing the top cover from the upper half of the styrofoam, take the packaging from the box and put
it on the floor. Place the fan in the recessed circle that the top cover was in.
(MOTOR COUPLING)
IMPORTANT SAFETY INFORMATION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN,
INSTALL THE THREADED DOWNROD INTO THE MOTOR COUPLING AND
Prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma • Lock™ downrod and ball assembly, keeping the wires
to one side of the cross pin.
NOTE: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
Step B. Thread the downrod into the motor coupling until it
stops turning, this will take at least four and a half full turns.
Step C. Securely tighten the locking bolt to ensure safe op-
eration of your fan.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the locking
bolt may cause the fan to separate from
the downrod during normal operation!
CROSSBAR
MOUNTING
BRACKET
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked
acceptable for ceiling fan support using the mount-
ing hardware provided with the outlet box.

INSTALLATION INSTRUCTIONS

PERMA • LOCK™ HARDWARE
LOCKING BOLT

FAN PREPARATION

LOCK THE ASSEMBLY

CEILING HARDWARE

WIRE NUT (4)

GETTING STARTED

B
EL
MOTOR
WIRES
TAPERED
THREAD
LOCKING
BOLT
ADDITIONAL HARDWARE
1" x 8-32 ROUNDED
HEAD SCREW (2)
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is
marked 'Approved for ceiling fan mounting' . If it is not, a new
box must be installed.
™
A
IR
DOWNROD & BALL
ASSEMBLY
GROUND
WIRE
DOWNROD
&
BALL
ASSEMBLY
MOTOR
COUPLING
1
2 " x 8-32 ROUNDED
/
4
HEAD SCREW (2)
FLAT WASHER (2)
5