Table of Contents
Advertisement
2.1 Overview
This chapter provides advice and instructions for unpacking and preparing your system for
setup. If your system is not already fully integrated with processors, system memory etc.,
refer to
Chapter 3
for details on installing those specific components.
Caution: Electrostatic Discharge (ESD) can damage electronic components. To prevent such
damage to PCBs (printed circuit boards), it is important to use a grounded wrist strap, handle
all PCBs by their edges and keep them in anti-static bags when not in use.
2.2 Unpacking the System
Inspect the box in which the SuperWorkstation SYS-730A-I was shipped, and note if it was
damaged in any way. If any equipment appears damaged, file a damage claim with the carrier
who delivered it.
The system should be situated in a clean, dust-free area that is well ventilated. Avoid areas
where heat, electrical noise and electromagnetic fields are generated. It will also require a
grounded AC power outlet nearby. Be sure to read the precautions and considerations noted
in
Appendix
A.
2.3 Preparing for Setup
Please read this section in its entirety before you begin the installation.
Choosing a Setup Location
•
The system should be situated in a clean, dust-free area that is well ventilated. Avoid areas
where heat, electrical noise and electromagnetic fields are generated.
•
This product is not suitable for use with visual display workplace devices according to §2
of the German Ordinance for Work with Visual Display Units.
Workstation Precautions
•
Review the electrical and general safety precautions in
Chapter 2
System Installation
16
Chapter 2: System Installation
Appendix
A.
Advertisement
Table of Contents
Troubleshooting
