Supermicro SuperWorkstation SYS-730A-I User Manual page 51

Replacing or Installing the Front Fan
1. Remove power from the system as described in Section 3.1 and remove the side cover
as described in Section 3.2.
2. Insert the four rubber pins through the front fan bracket and into the mounting holes in
the front fan.
3. Pull the rubber pins through the mounting holes of the system fan to secure the fan to
the chassis.
4. Lower the fan into the chassis, aligning the holes at the top of the front fan bracket with
the holes in the chassis.
5. Secure the fan to the chassis using the two screws provided.
Chapter 3: Maintenance and Component Installation
Figure 3-11. Installing the Front Fan
51