Supermicro SuperWorkstation SYS-730A-I User Manual page 46

Chapter 3: Maintenance and Component Installation
1
5 1
4
Release Tabs
Figure 3-7. Remove a Drive Carrier from the Cage
Removing and Installing 3.5" Hard Drives
1. Begin by removing power from the system as described in Section 3.1 and remove the
side cover as described in Section 3.2.
2. Rotate the hard drive cage outward.
3. Disconnect all of the cables from the hard drive.
4. Press the release tab on the side of the hard drive carrier.
5. Slide the hard drive carrier out of the cage.
46