Supermicro SuperWorkstation SYS-730A-I User Manual page 47

Figure 3-8. Remove a Drive Carrier from the Cage
6. If a hard drive is already present, pull the sides of the carrier and remove the drive from
the carrier.
7. Insert a new drive into the carrier and push the sides of the carrier together.
8. Insert the carrier into the cage. Slide the carrier towards the back of the cage until it
clicks into place.
9. Rotate the cage 90 degrees inward.
10. Connect the hard drive cables.
11. Plug the power cord back into the power module, replace the chassis cover and power-
up the system.
Chapter 3: Maintenance and Component Installation
1
6
47
1
6