Preparing To Install The Processor Heatsink Module (Phm) Into The Cpu Socket - Supermicro SuperWorkstation SYS-730A-I User Manual

Preparing to Install the Processor Heatsink Module (PHM) into
the CPU Socket
After assembling the Processor Heatsink Module (PHM), you are ready to install it into the
CPU socket. To ensure the proper installation, please follow the procedures below:
1. Locate four threaded fasteners (a, b, c, d) on the CPU socket.
d
(a, b, c, d: Threaded Fasteners)
2. Locate four peek nuts (A, B. C. D) and four rotating wires (1, 2, 3, 4) on the heatsink as
shown in the graphics below.
A, B, C, D: Peek Nut
1, 2, 3, 4: Rotating Wire
a, b, c, d: Threaded Fastener
Rotating Wire
Peek Nut
(Unlatched)
3. Check the rotating wires (1, 2, 3, 4) to make sure that they are at unlatched positions as
shown in the drawing below before installing the PHM into the CPU socket.
Chapter 3: Maintenance and Component Installation
b
CPU Socket
c
a
B
4
Rotating Wire
D
(latched)
CPU Socket
31
CPU Socket Pin1
Heatsink
2
Rotating Wire
C
Rotating Wire
A
Peek Nut
Threaded Fastener
3
1