Mounting The Pro Device - Siemens SIMATIC IPC477D Operating Instructions Manual

3.3

Mounting the PRO device

Requirement
● All packaging components and protective films have been removed.
● Siemens base adapter with screws
Note
Mounting without base adapter
If you install the device without a base adapter, you must adjust the mechanical interface
between the support arm or stand and the unit accordingly, including placement of an
appropriate seal on the mechanical interface of the device.
● A support arm or stand system from a third party (see section "Accessories (Page 25)")
including a
support arm or stand head (see
– Intermediate plate (see
– Coupling with screws without intermediate plate
● The following cables are fed through the stand or the support arm to which the device is
mounted:
– Protective conductor
– Power supply cable
– Data cables, e.g. USB
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD
or
NOTICE
Degree of protection for overall device
If you are using a support arm system or a stand system that does not have IP65
degree of protection or Enclosure Type 4X / 12 (indoor use only), IP65 degree of
protection and Enclosure Type 4X / 12 (indoor use only) are lost for the entire device.
Spray and water jets as well as penetrating substances can then damage the device.
Only use a support arm system or stand system that has IP65 degree of protection and
Enclosure Type 4X / 12 (indoor use only).
For even large connectors to fit, run their cables through the stand or support arm first,
for example, DVI or PROFIBUS.
①
figure below) and a proprietary adapter set:
②
figure below) with screws
Mounting and connecting the device
3.3 Mounting the PRO device
51