Expanding The Device And Assigning Device Parameters; Opening The Device; Opening The Built-In Unit - Siemens SIMATIC IPC477D Operating Instructions Manual

Expanding the device and assigning device
parameters
6.1

Opening the device

6.1.1

Opening the built-in unit

The device must be opened in order to add memory or install the internal CFast card. Read
the information in the section "ESD guideline (Page 133)" when doing this.
Opening device with expansions
To open devices with the PCIe card and/or DVD drive expansions, you first have to
dismantle these expansions. You can find additional information on this in the following
sections:
● Removing a PCIe card (built-in units with PCIe card without DVD drive) (Page 101)
● Installing and removing a DVD drive (built-in unit only) (Page 103)
● Removing a PCIe card (built-in units with PCIe card and DVD drive) (Page 103)
Opening device without expansions
For devices without expansions, only the rear panel of the device is removed.
Requirement
● The device is disconnected from the power supply.
● All cables are removed from the device.
● The device is removed.
● T10 screwdriver
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD
6
95