Preparing The Mounting Cutout - Siemens SIMATIC IPC477D Operating Instructions Manual

Display rotated 90° vertical from the standard position. The power supply is located at the
top.
1
3.1.3.2

Preparing the mounting cutout

Note
Stability of the mounting cutout
The material in the area of the mounting cutout must provide sufficient strength to guarantee
the enduring and safe mounting of the HMI device.
The force of the clamps or operation of the device may not lead to deformation of the
material in order to achieve the degrees of protection described below.
Note
Read the information in the section "Installation guidelines (Page 43)".
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD
CAUTION
Fire protection enclosure requirement not fulfilled
In the "Upright mounting in vertical position" mounting position, the device enclosure
does not satisfy the requirement of a fire protection enclosure.
If you want to operate the built-in unit in this mounting position, check if the built-in unit
has to meet the requirement for a fire protection enclosure in the desired operating area.
If in doubt, install the built-in unit in an enclosure that is compliant with the requirements
of sections 4.6 and 4.7.3 of the IEC/UL/EN/DIN-EN 60950-1 standard.
DVD operation not permitted
Operation of the DVD drive is not permitted in the "Upright mounting in vertical position"
mounting position.
For temperature specifications, see section "Environmental conditions (Page 149)".
Mounting and connecting the device
3.1 Preparing for mounting
39