Structure Of The Basic Adapter; Interfaces And Operator Controls For Pro Device - Siemens SIMATIC IPC477D Operating Instructions Manual

Overview
1.3 Design of the PRO device
1.3.1

Structure of the basic adapter

The base adapter comes with an adapter set. The base adapter and adapter set are required
for mounting on a support arm or stand and are available as accessories.
①
②
③
④
⑤
1.3.2

Interfaces and operator controls for PRO device

The figure of the interfaces applies to the PRO device. The assignment of the interfaces is
shown inside the terminal compartment cover.
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
24
Seal
Cable channel
Mechanical interface to the PRO device
Cover
Mechanical interface to support arm or stand
4 x USB port
Slot for external CFast card
Display port
COM1 port
DVI-I port
2 x Ethernet port
24 V DC power supply
On/off switch
PROFIBUS-DP/MPI interface (optional)
Protective conductor connection
USB 3.0 high speed/high current
Behind the cover
DPP
Serial interface, 9-pin D-sub connector
DVI connector for CRT or LCD monitor (VGA via DVI-
VGA adapter) with DVI interface
RJ45 Ethernet connection 1 and 2 for
10/100/1000 Mbps
interface RS 485, isolated, 9-pin D-sub socket
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD