Table of Contents
Advertisement
Taiko™ Banknote Validator
ENTERING TEST MODE
Diagnostic Tests are initiated using DIP Switch #1.
To enter the Diagnostic Test Mode, proceed as follows:
1. Turn DIP Switch #1 ON
2. Apply power to the Taiko
The Front Panel LED will flash White.
NOTE: DIP Switch #1 is used as the Enable/Disable Switch to
activate or deactivate each of the following Taiko™ Diagnostic Tests.
F
UNCTIONAL
Table 3 lists the various Taiko
settings.
Transport Motor Forward Rotation Test
Transport Motor Reverse Rotation Test
Part No. 960-100919R_Rev. 1
JCM Training Overview
™
T
ESTS
™
Table 3 Taiko TEST DIP Switch Settings
ON
OFF
Setting Function
DIP Switch Test
Aging Test
Solenoid Test
Acceptance Test
Entrance Flapper Test
Exit Flapper Test
Lecture Notes
Unit.
Unit Tests and their related DIP Switch
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
ON
ON OFF OFF OFF OFF OFF OFF OFF
ON
ON
ON
ON OFF OFF OFF ON OFF OFF OFF
ON OFF OFF ON
ON
9
ON
ON
ON
ON
ON
OFF OFF OFF OFF OFF OFF
ON
OFF ON OFF OFF OFF OFF
ON
ON
ON OFF OFF OFF OFF
ON OFF OFF OFF
ON
OFF ON
ON OFF OFF OFF
© 2017 JCM American Corporation
March, 2017
ON
ON
ON
Advertisement
Table of Contents
