C: Monitor Network - Omron SYSMAC C200HW-ZW3AT2-E-V2 Operation Manual

C: Monitor Network

5-8

C: Monitor Network

The number of times the test data was received by each node will be dis-
played in the "# OK" column. Each node can be checked for communica-
tions problems by comparing the value in the "# OK" column with the number
of times the test was repeated.
5. After confirming the test results, press the F9 (End) Key.
"C: Monitor Network" is used to display the status of the specified Controller Link
Network on the real-time basis.
The following information will be displayed.
Item
Communications
cycle time
(Comm cycle time)
Data link activity
(DataLink)
Network participation
(In netwk)
Data link
participation
(DtLnk join)
PC operating status
(PC Run)
PC error status
(PC err)
Communications
error status
(Comm err)
This monitoring is not possible when the PC to which the Controller Link Support
Software is connected or the computer on which the Controller Link Support
Software is running is not participating in the network.
Note The "Monitor Network" function can be used only for Controller Link Networks. If
networks other than Controller Link are specified, network status will not be dis-
played normally.
Meaning
Displays the latest communications cycle time of the
specified network.
Displays the data link operation status of the specified
network.
Displays the network participation status of each node as
follows:
YES: Participating in Network
No display: Not participating in Network
Displays the data link participation status of each node as
follows:
YES: Participating in data links
No display: Not Participating in data links
This item is not displayed when the data links are inactive.
Displays the operation mode of each PC as follows:
YES: User program is running on the PC
No display: User program is not running on the PC
This item is not displayed when the data links are inactive.
The user program may stop when an error occurs in DATA
LINK START or MONITOR mode. In this case, nothing will
be displayed.
YES is always displayed for the Controller Link Support
Board.
Displays the PC error status of each node as follows:
YES: Stopped due to an error
No display: Operating normally
This item is not displayed when the data links are inactive.
Nothing is always displayed for the Controller Link Support
Board.
Displays the communications error status of each node as
follows:
YES: Error or not participating in network
No display: Operating normally
This item is not displayed when the data links are inactive or
the local node is not participating in the data links.
Section 5-8
103