Omron SYSMAC C200HW-ZW3AT2-E-V2 Operation Manual page 94

L: Data Link
80
Note The nodes registered in the data link table for the specified node are
highlighted. They are the nodes that have data links to the specified
node.
Key
F4 (Pre Pg) When this key is pressed, the node addresses for which
Page Up the node status is displayed will change cyclically in the
following order:
1 to 16 → 17 to 32 → 33 to 48 → 49 to 62
F5 (Nxt Pg) When this key is pressed, the node addresses for which
Page Down the node status is displayed will change cyclically in the
following order:
49 to 62 → 33 to 48 → 17 to 32 → 1 to 16
F9 (Cancel) Stops updating the display and changes the F9 Key
function to "Start."
F9 (Start) Restarts updating the display and changes the F9 Key
function to "Cancel."
F10 (End) Closes the operating status display screen.
The meaning of each item is as follows:
Item
Communications Displays the current communications cycle time of the
cycle time Controller Link Network.
(Comm cycle
time)
Data link Displays the data link operating status, active/inactive on
(DataLink) the top and manual/automatic on the bottom.
Refresh cycle Displays the current data link refresh time (the period from
time the time the data link data is refreshed at the PC until the
(Refresh cycle) next refresh is completed) and the maximum data link
refresh time that has been measured since the data links
were started.
For nodes with a Controller Link Support Board, the refresh
cycle time is always 0 ms.
Data link table Displays whether data link tables have been set at the
(DataLink table) nodes displayed on the screen.
Section
Function
Meaning
5-3