Omron SYSMAC C200HW-ZW3AT2-E-V2 Operation Manual page 174

Using Modems
Connecting Online via Modems
This section describes how to connect online via modems. Be sure to set up and connect the modem before start-
ing the following procedure.
1. Start the communications software from the computer.
2. Dial the other party's phone number from the communications software.
From the communications software in terminal mode, enter the other party's phone number following "ATDT"
(underlined section).
Example: Using tone dialing
Wait until the modem connects to the modem at the PC.
When the line is connected, "CONNECT" will be displayed as shown below.
3. With the line connected, quit the communications software.
4. Enter the following command (underlined section) to start the Controller Link Support Software.
5. Set the following communications parameters using the System Setup of the Controller Link Support Software.
6. Operate the Controller Link Support Software as usual.
Terminating the Online Connection
When PC operations are completed, disconnect the line according to the following procedure.
Press the PHONE button on the modem or turn the modem OFF to disconnect the line.
160
ATDT045-123-4567
OK
CONNECT
C:\CLK>CLKSS
Item
Baud rate
Stop bit
Parity
Data bits
Unit No.
Destination PC
Operating level
Maximum node response time
(watchdog timer)
Note Set these items according to the system being used.
Setting details
2,400, 4,800, 9,600, or 19,200 bps
1 bit
Even
7 bit
Node number 0 (see note)
C, CV, or CS1 (see note)
Level 0 or 1 (see note)
10 seconds (see note)
Appendix B