Omron SYSMAC C200HW-ZW3AT2-E-V2 Operation Manual page 87

L: Data Link
If no comparison error is detected in all the specified nodes, "Compare OK"
will be displayed. In this case, press the F10 (End) Key to quit the compari-
son.
If comparison errors are detected, message "Will display differences. Speci-
fy node address" will be displayed along with the mode number of the small-
est node address with a comparison error.
5. Specify the node address of the node for which the comparison errors are to
be displayed. Enter the network address with Numeric Keys, then press the
Enter Key. The comparison error screen for the specified node will be dis-
played.
The comparison error screen differs depending on the location of the error.
• The following will be displayed when an inconsistency is found in the num-
ber of nodes set, first status word, link start word of area 1, or link start word
of area 2.
When the number of nodes set is inconsistent, the number of words in area
1, offset in area 1, the number of words in area 2, and offset in area 2 will
not be compared.
• The following will be displayed when an inconsistency is found in the num-
ber of words in area 1, offset in area 1, number of words in area 2, or offset
in area 2.
Section 5-3
73