Omron SYSMAC C200HW-ZW3AT2-E-V2 Operation Manual page 46

Connecting to a Node
32
For each DIP switch pin, ON is on the left side and OFF is on the right side.
No. Function
1 Communications
parameter settings (for
communications ports 1
and 2) (see note)
2 CTS switch
(communications port 1)
3 CTS switch
(communications port 2)
4 Reserved for system use ON
5 Loopback test
6 Test port selection
Setting Meaning
ON The communications parameters
for communications ports 1 and 2
are as follows:
Baud rate: 9,600 bps
Stop bits: 2 bits
Parity: Even
Data bits: 7 bits
Xon/Xoff control: No
Communications method: Full
duplex
OFF The values specified for the CPU
Bus Unit System in the PC are
used as communications
parameters. The initial values are
as follows:
Baud rate: 9,600 bps
Stop bits: 2 bits
Parity: Even
Data bits: 7 bits
Xon/Xoff control: Not
Communications method: Full
duplex
ON The CTS signal (ready to receive)
is always set to ON (0 V fixed.)
Always set this switch pin to ON
when connecting the Controller
Link Support Software.
OFF Cannot be set.
ON The CTS signal (ready to receive)
is always set to ON (0 V fixed.)
Always set this switch pin to ON
when connecting the Controller
Link Support Software.
OFF Cannot be set.
Cannot be set.
OFF Always set this bit to OFF.
ON Cannot be set when the
Controller Link Support Software
is connected.
OFF Always set this switch pin to OFF
when connecting the Controller
Link Support Software.
ON Cannot be set when the
Controller Link Support Software
is connected.
OFF Always set this switch pin to OFF
when connecting the Controller
Link Support Software.
Section 3-3