Setting Of Terminator - Toshiba TS2000 Instruction Manual

5.5

Setting of terminator

When using the conveyor synchronization function, setting of the terminator is
necessary because the encoder cable can be connected not only individually, but
in a row as shown in Fig. 5.13 below and the conveyor position can be identified
by each controller. The terminator setting is established by ON/OFF of SW4 (4
poles) equipped on the option (X8HL) printed board. A pair of SW4–1 and
SW4–2 can be used for CH1. Likewise, a pair of SW4–3 and SW4–4 can serve
for CH2. (See Table 5.1 below.)
All of four (4) poles of SW4 of the option (X8HL) printed board are
factory-set to "ON" before shipment.
Table 5.1 SW4 setting (When the SW is set ON, the terminator is set.)
SW No.
SW4–1
SW4–2
SW4–3
SW4–4
Controller 1
Encoder
INSTRUCTION MANUAL CONVEYOR SYNCHRONIZATION FUNCTION
Signal name
CH1A ON/OFF
CH1B ON/OFF
CH2A ON/OFF
CH2B ON/OFF
Fig. 5.13 Continuous connection of encoder
Setting
Terminator setting switch for
CH1 phase A data.
Terminator setting switch for
CH1 phase B data.
Terminator setting switch for
CH2 phase A data.
Terminator setting switch for
CH2 phase B data.
Controller 2
– 42 –
Remarks
Controller N
STE73828