Assa Abloy SARGENT IN Series Installation Instructions Manual page 22

9 Preparation of Connectors
CAUTION - Do not touch or allow debris to enter connector contacts.
Ensure connectors are covered with silicone dielectric compound
• Snip end of packet to dispense grease
• Ensure all connector pins and contacts (Fig. 9) are
covered - do not overfill or over-apply**
*Supplied tube contains 5 grams of silicone dielectric compound (grease)
**Evenly distribute grease, wiping away excess; full application requires
approximately 2.5 grams
IMPORTANT: Do not run wires through bottom hole in plate (Fig. 9) - it will
damage wires and the controller connector. Route wires around
flange, do not route wires through the flange hole (Fig. 9 ).
10 Installation of Connectors
Secure the following connectors (Fig. 10A, B):
A. Secure the 4-pin DPS connector.
B. Secure the 10-pin lock body assembly connector.
Secure Mounting Plate
• Tuck excess cable into wire hole on inside of door
• Secure the mounting assembly while ensuring proper
alignment of outside reader and fully tighten the (2)
through-bolts on the inside of the door to secure the
reader and plate to the door
C. Secure the 24-pin card reader connector (Fig. 10A, B)
D. Ensure all openings on back of secured reader connector are
covered completely with grease (Fig. 10B).
22 1-800-810-WIRE • www.sargentlock.com • A8151H
Important Note: Before you secure the connectors
SILICONE DIELECTRIC
COMPOUND
IN120 / IN220 Mortise Lock
(grease)*
FILL
FILL
Fig. 9
Reader
(24-pin)
Board-to-Board
Connector
FILL
Fig. 10B
APPLY
FILL
FILL
NO WIRES
THRU THIS
OPENING
C
A
B
Fig. 10A