Assa Abloy SARGENT IN Series Installation Instructions Manual page 10

IN220 (PoE) Installation Wiring (Continued)
Frame Harness Installation
A
Supplied by CI
B-Splice
Crimp Connector
Ceiling
24AWG
Stranded
Drain
Wire for
Earth
Ground in
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable drain wire
concealed in
shrink tubing
Molex-M
PoE Data Hinge
B
Frame
4-pin M
6-pin M
10 1-800-810-WIRE • www.sargentlock.com • A8151H
Components and wire harness supplied by McKinney. Suggested installation:
Cut end / ceiling-side PoE harness:
RJ45-M
Do not confuse pair numbers with pin numbers. A pair number is
used for reference only (eg: 10BaseT Ethernet uses pairs 2 & 3). The
pin numbers indicate actual physical locations on the plug and jack.
Hinge side of PoE (Frame) harness:
1. Feed cut end of harness into hole on hinge-side through single
access hole.
2. Push one connector back through the hole and feed into the other
access hole.
Each of the hinge-side harness connectors should end up thread-
ed through a different access hole and matched to the same size
pin connector from
the door harness:
• 4-pin male molex connector
• 6-pin male molex connector with ground wire
4-pin F
PoE Hinge
6-pin F
IN120 / IN220 Mortise Lock
TIA/EIA 568-B Standard Wiring
pin pin
1 8
8 1
4-pin F
Hinge-side harness connectors:
• 4-pin female molex connector
• 6-pin female molex connector with ground wire
Lock-side harness connectors:
• 4-pin female molex connector
• 6-pin female molex connector with ground wire
6-pin F
PIN Wire Pair
Number
1 White/Orange 2
2 Orange 2
3 White/Green 3
4 Blue 1
5 White/Blue 1
6 Green 3
7 White/Brown 4
8 Brown 4