Assa Abloy SARGENT IN Series Installation Instructions Manual page 18

4 Install Inside Rose and Inside Lever Assembly
1. Place inside rose flush against door surface and rotate first counter-clockwise to seat
the threads, then clockwise to securely tighten.
2. Slide lever onto spindle until fully seated. Be sure handle is horizontal and facing the hinge
side of the door. Push lever onto spindle so minimum gap is visible.
3. Tighten the set screw securely with a T20 Torx
4. Finish securely tightening (2) #12-24 lock body screws.
5. Before closing the door, test that the lever is functional and ensure
smooth operation of the latchbolt.
#12-24 screws
18 1-800-810-WIRE • www.sargentlock.com • A8151H
Fig. 4
IN120 / IN220 Mortise Lock
driver.
®
Inside of
Door
Spindle
Set Screw
Cat 5e cable and
ground wire from
hinge for IN220 (PoE)
Rose
Inside Lever