Assa Abloy SARGENT IN Series Installation Instructions Manual page 13

IN120 / IN220 Mortise Lock
2 Prepare Lock Body
2A Prepare 7900 Lock Body*
*If 7900 is type of lock being installed
1. Reverse Lock Hand (If Required)
Red surface of locking piece must face the
outside/locked side of door. To rotate locking
piece (Fig. 2A1):
a. Position lock body with red surface of
locking piece visible.
b. Insert blade type screwdriver into
locking piece slot to rotate lock-
ing piece toward back of lock body.
c. Rotate the locking piece 180° until
RED surface is on opposite side.
Note: Red indicates locked side (outside).
2. Reverse Latch Hand (If Required)
a. Rotate the latchbolt 180° (Fig. 2A2).
b. Flip deadlatch by hand to match bevel of latchbolt.
3. Install **Door Position Switch (DPS)
a. Push wire harness through raceway toward lock prep.
b. Push DPS firmly into place by hand.
Note: DO NOT TAP SWITCH WITH ANY TOOL.
c. Install magnet into door frame.
Push firmly into place by hand.
See instruction A7983.
CAUTION: if DPS is not installed or is installed improperly,
door status monitoring features will not function.
**Only required with the 7900 lock body.
Latchbolt
Deadlatch
Fig. 2A2
1-800-810-WIRE • www.sargentlock.com • A8151H
Locking piece
Fig. 2A1
Locking piece
Inside of
Door
DPS 4-Pin
Harness
13