Assa Abloy SARGENT IN Series Installation Instructions Manual page 11

IN120 / IN220 Mortise Lock
IN220 (PoE) Installation Wiring (Continued)
PoE Door Harness
C
Order of installation may vary. Refer to appropriate sections for instructions.
Hinge-side harness connectors:
• 4-pin male Molex connector
• 6-pin male Molex connector with ground wire
Lock-side harness connectors:
• Ring terminal
• Male RJ45 connector (crimped after cable is fed through door)
Notes:
• Connectors go on only one way. They cannot be plugged to incorrect position.
• Do not force and do not offset connectors.
• Be sure they are completely seated (flush).
4-pin F
6-pin F
PoE Lock
D
Order of installation may vary. Refer to appropriate sections for instructions.
1. Prop door open.
2. Using the ring terminal, carefully route the assembly through the door
channel toward lock.
*Do not terminate PoE harness (with RJ45 M) until
cable has been routed through door and inside
mounting plate assembly.
See Section 9, S
4-pin F 4-pin M
Drain Wire
6-pin F 6-pin M
10 - Installation of Connectors.
tep
RJ45-M
Cable
: CAT 5e (or higher),
26 AWG stranded,
shielded, 100ohm
1-800-810-WIRE • www.sargentlock.com • A8151H
IN220 PoE Lock
PoE Harness
(Cat 5e or higher) with
ground wire
11