Quick Reference Guide - Directed DIRECTECHS DB3 Installation Manual

2010 jeep liberty. 403.chrysler 7.34
Hide thumbs Also See for DIRECTECHS DB3:
Table of Contents

Advertisement

Quick Reference Guide

Sending commands to your vehicle
Whether you want to remote start the engine, lock/unlock the doors or pop the trunk,
there are 3 possible ways you can send commands to your vehicle, using the:
Factory remote.
Aftermarket remote.
Directed SmartStart application via your smartphone.
If applicable, you can also start the engine remotely by pressing the Lock button 3
times quickly on your factory remote.
Vehicle takeover with regular key
Close the vehicle doors, hood and trunk, then send
1
the Remote Start command to start the vehicle.*
Send the Unlock command on the factory or
2
aftermarket remote.*
Enter the vehicle, while making sure the factory
3
remote is inside with you.
Insert your key in the ignition barrel and turn it to the
4
ON position.
Depress the brake pedal, put the car in gear and
5
drive off.
* Icon and remote appearance may differ depending on the model purchased.
20
403.CHRYSLER 7.34 2010 Jeep Liberty
©2022 VOXX•DEI LLC. All rights reserved.
Press Remote
Start button*
Press Unlock on
either remote*
Enter vehicle
with remote
Key OUT
Key IN
Key IN
START
START
Ready to
drive off
Vehicle takeover with Push-to-Start (PTS)
Close the vehicle doors, hood and trunk, then send
1
the Remote Start command to start the vehicle.*
Send the Unlock command on the factory or
2
aftermarket remote.*
Complete the following steps within 45 seconds or the vehicle will shut down.
Enter the vehicle, while making sure the factory
3
remote is inside with you.
14:36
4
Press the PTS button twice.
Depress the brake pedal, put the car in gear and
5
drive off.
14:36
* Icon and remote appearance may differ depending on the model purchased.
14:36
Pit stop/idle mode
Key IN
Stop the vehicle in a safe parking spot and put the
1
START
START
gear in Park (P).
Press the Remote Start button on the transmitter.*
2
The parking lights will flash once to indicate the
vehicle is now in Pit Stop Mode.
Press the PTS button once or remove the key from
3
the ignition.
It is safe to leave the engine running and exit the
vehicle with the factory remote in hand.
4
Note: We recommend that you always lock the
doors of your vehicle when leaving it unattended.
* Icon and remote appearance may differ depending on the model purchased.
Press Remote
Start button*
Press Unlock on
either remote*
14:36
Enter vehicle
with remote
Ready to
drive off
Put
gear in
Park
&
Parking lights flash x1
Press Remote
Start button*
OR
14:36
Exit vehicle
with remote

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DIRECTECHS DB3 and is the answer not in the manual?

Questions and answers

Table of Contents