Directed DIRECTWIRE DIRECTECHS DB3 Installation Manual
Hide thumbs
Also See for DIRECTWIRE DIRECTECHS DB3:
- Installation manual (25 pages) ,
- Manual (6 pages) ,
- Installation manual (21 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Directed DIRECTWIRE DIRECTECHS DB3
Summary of Contents for Directed DIRECTWIRE DIRECTECHS DB3
- Page 1 403.VW09 v2.00 2014 Volkswagen Jetta GLI (Smart Key)
-
Page 2: Table Of Contents
Contents Introduction Vehicle function compatibilities Pre-installation and application warnings Wiring diagram Immobilizer interface Locating components in the vehicle Vehicle connections Module programming SmartStart/XL202 installation notes Connecting the module LED diagnostics and troubleshooting Parking light error codes Soft reset Hard reset Limited one year consumer warranty Quick reference guide... -
Page 3: Introduction
This module can only be flashed and configured using DirectLink at www.directechs.com or using the Directechs Mobile application for smartphones. Refer to “Connecting the module” for more information. 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... -
Page 4: Vehicle Function Compatibilities
Entry Monitoring Trunk/Hatch Pin * Odometer Brake Status (foot brake) 3x LOCK START (Start control using OEM Remote) E-Brake Status 3x LOCK STOP (Stop control using OEM Remote) 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... -
Page 5: Pre-Installation And Application Warnings
General notes: This section highlights important information for this specific firmware. Locks and trunk release output ONLY required if foor locks or trunk are not supported in data. For Key Wrap instructions refer to "Immobilizer Interface" section. 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... -
Page 6: Wiring Diagram
VESCM - Driver side under dashboard under dashboard) 42 25 Hood Pin Note: hood pin only required on vehicles not equipped with a factory hood pin. (+) Brake: Black/Red, pin 17 41 24 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... -
Page 7: Immobilizer Interface
- Make 4-6 loops and place them around the front of the plastic body of the vehicle’s coded key as shown above. - Test and secure mounted loops before reassembling the vehicle. 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... - Page 8 - Make 4-6 loops and place them around the front of the plastic body of the vehicle’s coded key as shown above. - Test and secure mounted loops before reassembling the vehicle. 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights...
-
Page 9: Locating Components In The Vehicle
Locating components in the vehicle 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... -
Page 10: Vehicle Connections
H2/9 Violet/Brown (MUX) Door Lock Toggle Output No Connection H2/10 Yellow/Black No Connection No Connection H2/11 Orange/Black No Connection No Connection H2/12 Blue/Red (-) Trunk Output No Connection 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... - Page 11 D2D 4-pin white connector (H4) Module Conn./Pin Color Description H4/1 Green H4/2 Black H4/3 Blue H4/4 RF 2-pin white connector (H5) Module Conn./Pin Color Description H5/1 No Connection H5/2 No Connection 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights...
-
Page 12: Module Programming
The LED turns ON solid green for 3 seconds, then turns OFF. Press the PTS button once more to turn the ignition OFF. You have successfully completed the module programming sequence. 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... -
Page 13: Smartstart/Xl202 Installation Notes
Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information. RF System, PKE & SmartStart BT combination Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information. 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... -
Page 14: Connecting The Module
2. Do NOT connect the 2-pin harness (on SmartStart). Power and ground will be provided by the DB3 D2D connector. 3. Connect SmartStart to DB3 using the D2D port. XL202 installation Connect XL202 to DB3 using the D2D port. 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... -
Page 15: Led Diagnostics And Troubleshooting
Flashes red x 11 BCM programming. Failed to program the BCM. Check if doors are locked. They need to be unlocked to solve the problem. Flashes red x 12 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... - Page 16 The smart key was not detected, which prevents the system from shutting down the vehicle. Flashes red x 3 Speed was detected. The vehicle was detected as moving, which prevents the system from shutting it down. Flashes red x 4 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights...
- Page 17 Lock Start is selected from the web in the flashing process. Flashes red x 7 Feature error. An RSR feature file mismatch was detected. Please contact Technical Support. Flashes red x 9 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights...
-
Page 18: Parking Light Error Codes
Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds until the & LED starts to flash orange and red. Solid Flashes Release the programming button. The LED turns ON solid red. & Release Solid 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... -
Page 19: Limited One Year Consumer Warranty
This Warranty gives you specific legal rights and you may also have other rights which vary from state to state. VOXX DEI LLC, 2351 J. Lawson Blvd., Orlando, Florida 32824 403.VW09 2.00 2014 Volkswagen Jetta GLI (Smart Key) ©2023 Directed. All rights... -
Page 20: Quick Reference Guide
Factory remote. Press the Remote Start button on the transmitter.* • Aftermarket remote. • Directed SmartStart application via your smartphone. & The parking lights will flash once to indicate the Parking lights flash x1 Press Remote vehicle is now in Pit Stop Mode. - Page 21 * Press & hold for 5 seconds to activate the trunk release (optional). * Icon and remote appearance may differ depending on the model purchased. SmartStart compatible This system is compatible with Directed SmartStart. For a complete list of supported features, please visit www.mysmartstart.com. What is SmartStart? Now you can remote start, lock and unlock your car just by pushing a button on your mobile device;...