Ml2000 Series Hand Reversing Instructions - Assa Abloy Corbin Russwin Access 3 Technical Manual

ML2000 Series Hand Reversing Instructions

Step 1) Move the Red locking screw to
side of lock-body being locked (Fig. 1)
Step 2) Push in latch then depress catch
plate with screw driver (Fig. 1)
Step 3) Pull latch out of lock-body
and turn latch over (Fig. 2)
Figure 2
Step 4) Push in latch while holding
screw driver behind latch tail (Fig. 3)
Note: Push in latch until catch plate is
no longer depressed (Fig. 4)
Step 5) Rotate lock front to match
bevel of door as shown (Fig. 5)
Figure 5
The warranty on Corbin Russwin products becomes void if the product is modified in any way, regardless of whether the modifications causes or contributes to any alleged defect. If a
Corbin Russwin product is modified it may no longer meet industry certification and quality control standards applicable to the original product and is no longer a genuine Corbin Russwin product.
Copyright © 2000-2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part without the express written permission of ASSA ABLOY Access
and Egress Hardware Group, Inc. is prohibited. Patent pending and/or patent www.assaabloydss.com/patents.
RED Locking Screw
82
ML2000 Parts Manual
Figure 1
MAKE SURE CATCH PLATE IS
EVEN W/ TOP SURFACE
GOOD
Figure 4
WARNING:
LOCK-IN CAN
OCCUR IF LATCH
IS NOT PROPERLY
Figure 3
INSTALLED
Catch Plate
BAD