Assa Abloy Corbin Russwin Access 3 Technical Manual page 364

Handing Instructions
Mortise Devices
5600(A) Series
To reverse, remove latch bolt and deadlatch, flip
both over and reinstall. Also flip cylinder set screw
and clamp assembly.
Illustration depicts typical lockbody with cover
removed. Only components relevant to lock handing
are shown. Other components vary according to
lock function.
x900 Lever Handle Trim
1. Remove cotter pin.
2. Remove castle nut.
3. Observe spring orientation:
LHR: Red spring (part # 651F61-8)
Short lead is at 11 o'clock and long lead is to lever side
of stump at 6 o'clock.
RHR: Blue spring (part # 651F628)
Short lead is at 11 o'clock and long lead is to lever side
of stump at 6 o'clock.
4. Remove round housing, spring and spacer.
5. Note orientation of Mgap" which governs rotation in
gear and remove gear.
6. Rotate lever 180°.
7. Flip gear over and reinstall, observing proper gap orien-
tation for new direction of rotation:
LHR 6 - 8 o'clock
RHR 4 - 6 o'clock
8. Install spring of opposite hand (color). Place spring
around spindle with long lead against gear and to lever
side of post. Place housing (gap side toward lever) over
spring and spindle until square in housing begins to slide
down on spindle. While applying downward pressure
on housing, wind short lead of spring toward lever until
housing snaps Into place.
9. Replace spacer in housing. Spring, housing and spacer
should now be oriented as indicated in step 3 above.
Note: Housing gap will always be to the lever side and
spring will be slightly pre loaded when properly installed.
10. Be sure lever thimble is seated properly in escutcheon.
Reinstall nut but do not over tighten. Lever should rotate
freely.
11. Replace cotter pin.
ED4000, ED5000 Parts Manual
68