HP rx2600 Operation And Maintenance Manual page 93

using MP via the mp LAN port
If you have not already configured your MP LAN port, do so now (page 3-26).
1. Using a telnet client, log on to the system with the Host Name provided by your Network
Administrator.
NOTE: All IP addresses and Hostnames should be provided by your Network Administrator.
For example:
C:\> telnet MP_Host_Name
The MP command mode login will display in the terminal window:
HP Management Processor
Firmware Revision E.02.10 Oct 1 2002,10:28:32
(c) Copyright Hewlett-Packard Company 1999-2002. All Rights Reserved.
Type Ctrl-B to activate the MP Command Interface
2. Press Ctrl -
3. The MP command mode prompt displays:
HP Management Processor
Firmware Revision E.02.10 Oct 1 2002,10:28:32
(c) Copyright Hewlett-Packard Company 1999-2002. All Rights
Reserved.
************************************************************
No MP users are currently configured and remote access is enabled.
Set up a user with a password (see SO command)
Disable all types of remote access (see EL and ER commands)
***************************************************************
MP Host Name: fstl3a
MP>
4. You can now enter commands. To run an individual command:
a. Type the command at the MP command prompt.
b. Press
operations and maintenance guide
B . At the login and password prompts, press
System Name: fstl3a
MP ACCESS IS NOT SECURE
OR
Enter to execute the command.
System Configuration
Enter .
3–25