HP rx2600 Operation And Maintenance Manual page 64

Installing or Replacing Parts and Accessories
replacing the system battery
1. Lift up on the battery holder retaining clip with a flat-head screwdriver and slide the battery
into its holder. The positive
Ä
CAUTION: Lift the battery just high enough to clear its holder. Too much stress on the battery holder
retaining clip may break it.
2. Replace the processor airflow guide.
3. Replace the system cover(s), reconnect all of the power and external cables and turn on the
system.
4. Execute time at the EFI prompt to verify that the battery has been installed correctly.
You may need to reset the system time and date using the EFI time and date commands.
Once you have set the time, turn the system off, unplug the power cord, and wait for a minute
before turning it back on. Execute the time and date commands again. If the time and date
are now correct, you have installed the battery correctly.
removing the management card battery
1. Remove the Management Card from the system.
2. Lift up on the battery and push on the back of it with a small flat-head screwdriver. This will
remove the battery from its holder.
Ä
CAUTION: Lift the battery just high enough to clear its holder. Too much stress on the battery holder
retaining clip may break it.
Remove the Management Card's Battery
replacing the management card battery
1. Lift up on the battery holder retaining clip with a small flat-head screwdriver and slide the
battery into its holder. The positive
Ä
CAUTION: Lift the battery just high enough to clear its holder. Too much stress on the battery holder
retaining clip may break it.
2. Re-install the Management Card in the system.
3. Replace the system cover(s), and reconnect all of the power and external cables.
2–46
(+)
side of the battery should face up.
(+)
side of the battery should face up.
operations and maintenance guide