HP rx2600 Operation And Maintenance Manual page 89

select active standard error devices
Use this option to define the devices that will display error messages from the system console.
This menu is identical to
different configurations for Output and Error console. For correct operation:
■
When changes are made to either Output or Error console menus, the identical change must
be made in both menus.
■
When changing serial devices, changes must be made to Output, Input, and Error menus for
proper operation.
using the security/password menu
To change the administrator and user passwords:
Security/Password Menu
1. Select
2. Select either:
❏ Set Administrator Password
❏ Set User Password
3. Select:
❏ Set Administrator Password
❏ Enable/disable Password
❏ Help
4. When you are finished, select
If you forget your passwords, they can be reset using an MP command. To reset the system
passwords:
If your system has an MP card:
»
Run the MP card
Commands‚" page 3-28).
If your system does not have an MP card, you must reset the passwords using a jumper on the
system board:
1. Power down the system and unplug the AC power cord.
2. Place a jumper between pins 7 and 8 on J96 on the system board behind the battery.
7
8
Password Reset Jumper
3. Plug in the AC power cord and wait for the BMC heartbeat LED on the system board to start
blinking green. This should take about 5 seconds from the time you plug in the power cord.
4. Unplug the AC power cord again and remove the jumper.
operations and maintenance guide
Console Output Devices
for assistance
Exit
command to reset the administrator and user passwords (see "MP
bp
. The zx6000/rx2600 does not support
.
Set User Password
or
to specify whether a password is required
.
System Configuration
to set a new password
3–21