HP rx2600 Operation And Maintenance Manual page 59

8. Screw in the four heatsink captive screws.
Screw in the Heatsink and Processor Screws
9. Connect the power cable for the processor turbo fan to its connector on the system board.
10. Slide the power module on the system board metal mounting bracket so that the power
module connector connects with its connector on the processor. Align the two mounting
screw holes on the power module with their screw holes on the system board's metal
mounting bracket. Screw in the power module mounting screws.
11. Replace the processor airflow guide and connect the power module power cable and turn on
the system.
info cpu
12. Run
system board
Ä
CAUTION: Some system settings are saved to the LED status panel. If you are replacing both the LED
status panel and the system board, they must be replaced one at a time to avoid loss of system settings.
First replace one component, then turn on the system and boot to the EFI prompt. After confirming that the
first component has been replaced successfully, shut down the system and replace the second
component.
operations and maintenance guide
at the EFI shell prompt to verify that the processor works.
Installing or Replacing Parts and Accessories
2–41