HP rx2600 Operation And Maintenance Manual page 35

3. Squeeze inward on the colored release clip on the hard drive release lever.
Squeezing Inward on the Hard Drive Release Clip
4. Pull outward on the release lever to remove the drive from the system.
Removing the Hard Disk Drive from the System
replacing a hard drive
Ä
CAUTION: See your OS documentation for instructions on replacing hot-swap hard drives in your OS
before beginning this procedure.
1. Shut down the OS.
2. Insert the hard disk drive into the drive bay from which you removed the drive and push
inward on the release lever until the drive no long slides forward. You must leave the release
lever in the open position, as shown, when you push the drive into the system.
3. Push in on the release lever to secure the drive in the bay and to ensure that the drive
connector is seated properly.
4. Reset the system to the EFI Boot Maintenance Menu to rescan the hard drives.
Use the EFI shell
operations and maintenance guide
map
command to verify that the new drive has successfully been installed.
Installing or Replacing Parts and Accessories
2–17