HP rx2600 Operation And Maintenance Manual page 92

System Configuration
using MP via the serial console port
To enter MP command mode using the Serial Console Port:
1. Connect the system to a remove device:
a. Connect the 25-pin end of a serial cable to the MP card 25-pin Serial Port, on the rear
panel of the system.
b. Connect the console connector on the serial cable to your remote device.
2. Configure the terminal emulation software with these settings:
❏
Terminal emulation: VT100+
❏
Baud rate: 9600
NOTE: The EFI
❏
Bits: 8
❏
Parity: None
❏
Stop Bits: 1 (one)
❏
Flow Control: None
3. Using the terminal emulation software, connect to the system with a direct connection.
4. Plug in the system. Do not turn it on.
The MP card boots to the MP command mode login:
HP Management Processor
Firmware Revision E.02.10 Oct 1 2002,10:28:32
(c) Copyright Hewlett-Packard Company 1999-2002. All Rights Reserved.
Type Ctrl-B to activate the MP Command Interface
-
5. Press Ctrl
The MP command mode prompt will display:
HP Management Processor
Firmware Revision E.02.10 Oct 1 2002,10:28:32
(c) Copyright Hewlett-Packard Company 1999-2002. All Rights Reserved.
********************************************************************
No MP users are currently configured and remote access is enabled.
Set up a user with a password (see SO command)
Disable all types of remote access (see EL and ER commands)
*********************************************************************
MP Host Name: fstl3a
MP>
6. You can now enter commands. To run an individual command:
a. Type the command at the MP command prompt.
b. Press
3–24
command does not change the MP card serial port speed.
baud
B . At the login and password prompts, press
System Name: fstl3a
MP ACCESS IS NOT SECURE
OR
to execute the command.
Enter
Enter .
operations and maintenance guide