7.3 Settings and related instruction words
The following type1 controller instruction words can be used for EN655 settings and its related
instruction words. For details, refer to the Unified Controller nV series type1 light Functional Manual
(6F8C1221).
7.3.1
Time Setting Request USEND_N
This sets the module time of EN655. This is used as the time for records.
Command details
Time Setting Request
7.3.2
Station Check Request USEND_N
This is a function that checks the existence of a specified station. This is equivalent to the Ping
command.
Command details
Station Check Request
REMARK
・ Since the operation mode control request is issued from the controller's firmware, there is
no operation mode command.
・Since the module parameters of EN655 are configured using the engineering tool, there are
no parameter setting and router IP address request commands.
7.3 Settings and related instruction words
Command
16#0318
Command
16#0314
UnifiedControllernvseriesEthernetModule(EN655)InstructionManual
Note
-
Note
-
57