Toshiba nv Series Instruction Manual page 22

Chapter 2 Installation and Wiring
6F8C1566
8
Before installing or removing the module,
WARNING
make sure that the power of the I/O base unit
to which the EN655 module is installed is
turned off.
Otherwise, it may cause an electric shock.
Do not touch the interior of the product except
WARNING
the switches.
It may cause an electric shock.
Install it under an environment that satisfies
CAUTION
the product specifications.
When installing it under an environment that does not
satisfy the product operating temperature range, apply
forced cooling with cooling equipment.
Operating temperature range: 0 to 55C
Before installation or wiring, remove the static
CAUTION
electricity from your body.
The static electricity accumulated in the human body may
cause failure of the product.
Do not touch the cables carelessly.
CAUTION
Applying stress to the cables may cause malfunction or
accidents.
Do not perform wiring, insertion of the module,
CAUTION
or installation, removal, or replacement of the
base unit while the power is on.
It may cause an electric shock or malfunction.
When installing the product to the I/O base unit, be
careful not to break or bend the pins of the G2 I/O bus
connector.
When installing the product to the I/O base
CAUTION
unit, do not to break or bend the pins of G2 I/O
bus connector.
If it is hard to insert the module to the I/O base
CAUTION
unit, remove it and then try to install it again
rather than trying to install it forcefully.
Mandatory
Prohibited
Mandatory
Mandatory
Prohibited
Prohibited
Prohibited
Mandatory